#Login Register
creating the hole for the sensor
  • 0 Vote(s) - 0 Average

11-08-2009, 04:17 PM #1
SDJeff Newbie *
Status: Offline Posts:1 Threads:1 Joined:Nov 2009
Sometimes, I find drilling into concrete a a bit of a challenge depending in the slab; some slabs seem harder than others and control of the bit is more difficult. QUESTION: What factors make a hole unsuitable for testing? I've had cases where the depth was right but the sensor would not go in even using the tools and recommended methods; then, after one more (in and out) with the bit, the the sensor went in easily without much effort. If the sensor goes in too eaisly is the hole still usable?

11-09-2009, 04:39 PM #2
Ben Newbie *
Status: Offline Posts:5 Threads:1 Joined:Sep 2008
I'm wondering if your drill bit is worn down. My sensors are never 'easy' to put in, but I've noticed it is more difficult when I use an older bit. W hen I drill in concrete the two things my bit needs to be is: relatively new and have a pyramid tip.

Possibly Related Threads...
Thread / Author Replies / Views Last Post
61 Replies 157,073 Views
Last Post by Ernesto
12-10-2012, 04:48 PM
1 Replies 11,765 Views
Last Post by rthompson
02-20-2009, 12:54 PM
3 Replies 17,571 Views
Last Post by rthompson
11-04-2008, 10:03 AM

Users browsing this thread:
1 Guest(s)