Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
50% fail rate
09-13-2011, 05:58 PM,
#10
RE: 50% fail rate
(09-13-2011, 05:50 PM)eaadams Wrote:  So you mitigate the area of the test or the whole slab with one high test?

For example patient room #206 is high, room #207 is fine, #205 is fine, and the hallway is fine. Do you just mitigate room #206?

We retest and figure out why. Then use reasoning to determine the course of action. Like I said, if the rooms are all 78% and one area is 90%, my official recommendation is to follow the book and mitigate it all, but I wouldn't be surprised (and don't believe there would ever be a problem) if we mitigate the high area and let the rest go.

This isn't common. I'll tell you where it happens a lot though.... Trenches for new service. We have mitigated just the trenches. Or areas that are on grade next to basement areas. Areas poured much thicker for footings. It does happen.
JD Grafton
Concrete Answers for Flooring Problems
[email protected]
Quote this message in a reply


[-]
Share/Bookmark (Show All)
Facebook Twitter Linkedin Technorati Digg MySpace Delicious

Messages In This Thread
50% fail rate - eaadams - 05-27-2011, 10:55 AM
RE: 50% fail rate - EWagner - 05-27-2011, 03:55 PM
RE: 50% fail rate - eaadams - 05-27-2011, 04:57 PM
RE: 50% fail rate - CC Solutions - 05-30-2011, 11:18 AM
RE: 50% fail rate - eaadams - 05-30-2011, 01:24 PM
RE: 50% fail rate - CC Solutions - 09-12-2011, 05:43 PM
RE: 50% fail rate - eaadams - 09-13-2011, 03:07 PM
RE: 50% fail rate - CC Solutions - 09-13-2011, 05:44 PM
RE: 50% fail rate - eaadams - 09-13-2011, 05:50 PM
RE: 50% fail rate - CC Solutions - 09-13-2011, 05:58 PM
RE: 50% fail rate - eaadams - 09-13-2011, 06:01 PM
RE: 50% fail rate - CC Solutions - 09-13-2011, 06:04 PM