Help
Advanced Search
|
Cork flooring
|
|
12-21-2012, 08:40 AM
Post: #22
|
|||
|
|||
|
RE: Cork flooring
Installation was a snap... Literally!
The plank cork was a bit tighter, I think the bigger size pieces in the office were not as tight on one edge. There always seemed to be a hairline crack in the same point of each tile joint. The planks are amazingly tight, the manufacturer must have some impressive machinery making these products to install so tightly. JD Grafton Concrete Answers for Flooring Problems JGrafton@ccsolves.com |
|||
|
|
« Next Oldest | Next Newest »
|
![[-]](images/collapse.gif "[-]") |
|||||||
 |
 |
 |
 |
 |
 |
 |
|
| Messages In This Thread |
|
Cork flooring - CC Solutions - 12-01-2012, 09:37 AM
RE: Cork flooring - CCR - 12-01-2012, 11:55 AM
RE: Cork flooring - Ernesto - 12-01-2012, 05:25 PM
RE: Cork flooring - CC Solutions - 12-01-2012, 06:52 PM
RE: Cork flooring - CCR - 12-02-2012, 10:21 AM
RE: Cork flooring - Rubensgt40 - 12-02-2012, 03:00 PM
RE: Cork flooring - CC Solutions - 12-03-2012, 01:32 PM
RE: Cork flooring - eaadams - 12-03-2012, 02:06 PM
RE: Cork flooring - CCR - 12-03-2012, 03:15 PM
RE: Cork flooring - Rubensgt40 - 12-03-2012, 06:55 PM
RE: Cork flooring - CC Solutions - 12-04-2012, 10:41 AM
RE: Cork flooring - Ernesto - 12-04-2012, 08:40 PM
RE: Cork flooring - CC Solutions - 12-05-2012, 07:46 AM
RE: Cork flooring - CC Solutions - 12-07-2012, 07:18 PM
RE: Cork flooring - CCR - 12-09-2012, 05:55 AM
RE: Cork flooring - CC Solutions - 12-09-2012, 09:42 AM
RE: Cork flooring - CCR - 12-09-2012, 10:19 AM
RE: Cork flooring - CC Solutions - 12-09-2012, 10:42 AM
RE: Cork flooring - CCR - 12-09-2012, 11:11 AM
RE: Cork flooring - CC Solutions - 12-20-2012, 09:38 PM
RE: Cork flooring - CCR - 12-21-2012, 07:20 AM
RE: Cork flooring - CC Solutions - 12-21-2012 08:40 AM
RE: Cork flooring - CCR - 12-21-2012, 09:11 AM
RE: Cork flooring - CC Solutions - 12-21-2012, 10:05 AM
RE: Cork flooring - eaadams - 12-22-2012, 11:49 AM
RE: Cork flooring - CC Solutions - 12-22-2012, 03:07 PM
RE: Cork flooring - jim decker - 04-29-2013, 08:36 PM
|
