improper probe depth

Thread Rating:

0 Votes - 0 Average
1
2
3
4
5

Threaded Mode--> | Linear Mode

improper probe depth

02-28-2012, 08:44 AM

Post: #4

Rrozema
Newbie

Posts: 3
Joined: Feb 2012

RE: improper probe depth

One more question: When using the 3/4" drill bit w/the small pilot drill on the end, what is the proper depth measurement for probe holes? From the tip of the small pilot drill, or the end of the 3/4" main drill body?

« Next Oldest | Next Newest »

Share/Bookmark (Show All)

Messages In This Thread

improper probe depth - Rrozema - 02-23-2012, 01:00 PM

RE: improper probe depth - rapidrhrep - 02-23-2012, 01:51 PM

RE: improper probe depth - Rrozema - 02-23-2012, 02:22 PM

RE: improper probe depth - Rrozema - 02-28-2012 08:44 AM

RE: improper probe depth - rapidrhrep - 03-01-2012, 07:43 AM

RE: improper probe depth - CC Solutions - 03-01-2012, 12:47 PM

RE: improper probe depth - Rubensgt40 - 03-04-2012, 03:56 PM

RE: improper probe depth - CCR - 03-09-2012, 06:14 AM

RE: improper probe depth - GP-CA - 03-23-2012, 02:24 PM

RE: improper probe depth - Ernesto - 03-23-2012, 07:51 PM

RE: improper probe depth - CC Solutions - 03-24-2012, 06:12 AM