ASTM 2170-11

[CC Solutions]

(10-03-2011 03:30 PM)rapidrhrep Wrote:  YAWN-Nappy time over


Is RapidRH 4.0 compatible with ASTM 2170-11?

NO manufacturer in the marketplace, that I am aware of, is 100% compatible with this latest revision.

Jason said the sleeve must be the entire depth of the hole. He did not say if the sleeve can be two piece.

JD-I really liked this comment.

Jason

WELL Sleeves can be two pieces. Much easier to adjust for depth. The anti-tank weapons I used to shoot in the Army had a two-piece tube that extended out to make the barrel that fired the rocket. You could do something like that (without the explosives though... Aw heck, make every hundreth one a 'surprise!' to keep us sharp.)