Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
JD's ref: RH and MVER conversion explanation
03-23-2013, 04:35 PM,
#2
RE: JD's ref: RH and MVER conversion explanation
I am not a big fan of doing RH and MVER since it's possible to have an acceptable MVER but high RH. The decision makers then base the installation approval on the low MVER only to experience a failure when the RH builds within the slab. I only do MVERs if it's insisted because the floor covering or coating manufacturer doesn't recognize RH for their product.
JK Nixon
Concrete Restoration Services, LLC
Pittsburgh, PA
http://www.rhtester.com
Quote this message in a reply


[-]
Share/Bookmark (Show All)
Facebook Twitter Linkedin Technorati Digg MySpace Delicious

Messages In This Thread
RE: JD's ref: RH and MVER conversion explanation - CCR - 03-23-2013, 04:35 PM