• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
50% fail rate

#7
The question was posed in Texas. But, my theory is that perhaps the manufacturers of flooring need to have some more nuanced rH specs.

Usually, one test over the rH requirement fails the floor. Perhaps there needs to be an ASTM standard where if you put X probes, you should do X/Y for the number of probes that need to meet rh Spec? Or perhaps some other deviation.

JD - what do you do in a hospital and one probe in one room comes in high? You don't mediate the whole building. Do you retest just there? Do you drill a new hole and new probe? where, how far away from high test?

Reply


Messages In This Thread
50% fail rate - eaadams - 05-27-2011, 10:55 AM
RE: 50% fail rate - EWagner - 05-27-2011, 03:55 PM
RE: 50% fail rate - eaadams - 05-27-2011, 04:57 PM
RE: 50% fail rate - CC Solutions - 05-30-2011, 11:18 AM
RE: 50% fail rate - eaadams - 05-30-2011, 01:24 PM
RE: 50% fail rate - CC Solutions - 09-12-2011, 05:43 PM
RE: 50% fail rate - eaadams - 09-13-2011, 03:07 PM
RE: 50% fail rate - CC Solutions - 09-13-2011, 05:44 PM
RE: 50% fail rate - eaadams - 09-13-2011, 05:50 PM
RE: 50% fail rate - CC Solutions - 09-13-2011, 05:58 PM
RE: 50% fail rate - eaadams - 09-13-2011, 06:01 PM
RE: 50% fail rate - CC Solutions - 09-13-2011, 06:04 PM

Digg   Delicious   Reddit   Facebook   Twitter   StumbleUpon  


Users browsing this thread:
1 Guest(s)