10-25-2011, 08:57 PM
I had a testing firm (very reputable) tell me today there is a way that Wagner rapid rh can get a false high. He said that residual dust can cause a false high reading.
On my next set of tests I'm going to have the tester poorly clean out a test site hole and do a normal test hole next to it. Should tell me an answer.
Does dust in the hole cause a high reading?
Our webinar actually touches on this. The testing company you spoke with is inaccurate. The dust will not cause a false high overall. The dust MAY slow the equilibration of the probe in the hole. These two explanations are very different. Bottomline, it is important to get that hole clean so you can take full advantage of all of the positive things the Rapid RH brings to the table.
Is the webinar different from the YouTube videos?
Shouldn't the dust settle after 12 or 24 hours? Is it the dust on the senors that can do it? I don't see how there can be zero dust when your shoving a sensor down a hole thats tight anyhow. It has to make some dust. Can you put a video camera in a hole for us to check and see Jason?
ernesto - I think that is what Jason is saying "The dust MAY slow the equilibration of the probe"
@EA Not all of the webinar video segments are posted on the website.
@ernesto I think I'm going to pass on trying to McGyver a camera to go in the hole.
Bottomline: Clean out the hole properly and the equilibration rate will be much better.
hrm ok I'll break down and do the webinar then...
I had assumed it was the same as the Youtube vids.
I saw a camera used recently to scope a drain that was depositing rain water into a slab. Oh what a disaster.
ERRR if you can't figure it out w/o a camera it is inapplicable in the real world.