#Login Register
creating the hole for the sensor
  • 0 Vote(s) - 0 Average


11-08-2009, 04:17 PM #1
SDJeff Newbie *
Status: Offline Posts:1 Threads:1 Joined:Nov 2009
Sometimes, I find drilling into concrete a a bit of a challenge depending in the slab; some slabs seem harder than others and control of the bit is more difficult. QUESTION: What factors make a hole unsuitable for testing? I've had cases where the depth was right but the sensor would not go in even using the tools and recommended methods; then, after one more (in and out) with the bit, the the sensor went in easily without much effort. If the sensor goes in too eaisly is the hole still usable?








Messages In This Thread
creating the hole for the sensor - SDJeff - 11-08-2009, 04:17 PM
RE: creating the hole for the sensor - Ben - 11-09-2009, 04:39 PM

Possibly Related Threads...
Thread / Author Replies / Views Last Post
61 Replies 94,909 Views
Last Post by Ernesto
12-10-2012, 04:48 PM
1 Replies 8,272 Views
Last Post by rthompson
02-20-2009, 12:54 PM
3 Replies 12,453 Views
Last Post by rthompson
11-04-2008, 10:03 AM

Users browsing this thread:
1 Guest(s)