Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ray Thompson Article in FCI
07-12-2012, 01:01 PM
Post: #5
RE: Ray Thompson Article in FCI
If all vinyl shrinks then you should compression fit every seam, no?

Many vinyl manufacturers call for gaping high quality vinyl the width of a credit card before heat welding. When we later get a complaint of a seam bulging on both sides of a seam it is usually because the vinyl grew, not shrink. The same goes for most recycled rubber floors, when an installer compression fits those (like you would normal rubber) you also get seam bulging.
Find all posts by this user
Quote this message in a reply
Post Reply 


[-]
Share/Bookmark (Show All)
Facebook Twitter Linkedin Technorati Digg MySpace Delicious

Messages In This Thread
Ray Thompson Article in FCI - eaadams - 07-02-2012, 10:30 AM
RE: Ray Thompson Article in FCI - eaadams - 07-09-2012, 01:29 PM
RE: Ray Thompson Article in FCI - eaadams - 07-12-2012 01:01 PM
RE: Ray Thompson Article in FCI - eaadams - 07-18-2012, 11:02 AM