#Login Register
Cork flooring
  • 0 Vote(s) - 0 Average


12-21-2012, 08:40 AM #22
CC Solutions Concrete Moisture Evangelist *******
Status: Offline Posts:1,065 Threads:69 Joined:Dec 2009
Installation was a snap... Literally!

The plank cork was a bit tighter, I think the bigger size pieces in the office were not as tight on one edge. There always seemed to be a hairline crack in the same point of each tile joint. The planks are amazingly tight, the manufacturer must have some impressive machinery making these products to install so tightly.

JD Grafton
Concrete Answers for Flooring Problems
JGrafton@ccsolves.com








Messages In This Thread
Cork flooring - CC Solutions - 12-01-2012, 09:37 AM
RE: Cork flooring - CCR - 12-01-2012, 11:55 AM
RE: Cork flooring - Ernesto - 12-01-2012, 05:25 PM
RE: Cork flooring - CC Solutions - 12-01-2012, 06:52 PM
RE: Cork flooring - CCR - 12-02-2012, 10:21 AM
RE: Cork flooring - Rubensgt40 - 12-02-2012, 03:00 PM
RE: Cork flooring - CC Solutions - 12-03-2012, 01:32 PM
RE: Cork flooring - eaadams - 12-03-2012, 02:06 PM
RE: Cork flooring - CCR - 12-03-2012, 03:15 PM
RE: Cork flooring - Rubensgt40 - 12-03-2012, 06:55 PM
RE: Cork flooring - CC Solutions - 12-04-2012, 10:41 AM
RE: Cork flooring - Ernesto - 12-04-2012, 08:40 PM
RE: Cork flooring - CC Solutions - 12-05-2012, 07:46 AM
RE: Cork flooring - CC Solutions - 12-07-2012, 07:18 PM
RE: Cork flooring - CCR - 12-09-2012, 05:55 AM
RE: Cork flooring - CC Solutions - 12-09-2012, 09:42 AM
RE: Cork flooring - CCR - 12-09-2012, 10:19 AM
RE: Cork flooring - CC Solutions - 12-09-2012, 10:42 AM
RE: Cork flooring - CCR - 12-09-2012, 11:11 AM
RE: Cork flooring - CC Solutions - 12-20-2012, 09:38 PM
RE: Cork flooring - CCR - 12-21-2012, 07:20 AM
RE: Cork flooring - CC Solutions - 12-21-2012, 08:40 AM
RE: Cork flooring - CCR - 12-21-2012, 09:11 AM
RE: Cork flooring - CC Solutions - 12-21-2012, 10:05 AM
RE: Cork flooring - eaadams - 12-22-2012, 11:49 AM
RE: Cork flooring - CC Solutions - 12-22-2012, 03:07 PM
RE: Cork flooring - jim decker - 04-29-2013, 08:36 PM

Users browsing this thread:
1 Guest(s)