Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Concrete floor and laminate
03-23-2011, 05:13 PM (This post was last modified: 03-23-2011 05:27 PM by Ernesto.)
Post: #21
RE: Concrete floor and laminate
Did I say use a moisture mitigation system on top of the K-15? Where? Cool
Where did I say to put K-15 under the moisture mitigation system? Cool
If there's no contaminants then no shotblasting is needed, you can simply scarify.

But really, what slab in a house is not going to get a floorcovering treatment? The concrete people need to start broom finishing the slabs. Everything sticks better.

Oh and you didn't copy the full text.

Surface Preparation:
Surfaces must be absorptive, clean, free from loose materials,
oil, grease, sealers, curing compounds, waxes, silicates, laitance,
and all other surface contaminants that may inhibit proper bond.
Completely remove cutback adhesive residue or other surface
contaminants by shotblasting. All surfaces to be treated must
have a profile of CSP 2-3 (similar to light broom finish), as
defined by ICRI (International Concrete Repair Institute,
Guideline No. 03732).
Surface areas requiring patching or leveling must be treated
using Durabond® Webcrete® 95, Webcrete 98 or Duralevel®
83P Fast Set patches/underlayments on top of the D-261
Extreme Moisture Vapor Barrier Coating according to label
instructions. Durabond Extreme Primer must be used prior to
the installation of these cementitious products

Stephen Perrera dba
Top Floor Installation Co.
http://www.tucsonazflooring.com
http://www.floorsavior.com
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


[-]
Share/Bookmark (Show All)
Facebook Twitter Linkedin Technorati Digg MySpace Delicious

Messages In This Thread
Concrete floor and laminate - morrisey - 03-21-2011, 08:03 AM
RE: Concrete floor and laminate - Ernesto - 03-23-2011 05:13 PM